Posted by Ralphwd45 on February 07, 2014 at 15:15:25 from (74.209.55.76):
I have a 3 sided shop bldg., 36'x30', with dirt floor. It has 3 12' bays, which I will eventualy get around to pouring a floor, probably one bay at a time. I put up track under the front eve, and am in the process of building 3 sliding doors to enclose the front. When the weather warms up some, I would like to build a masonary chimney in the middle of the center bay, for a wood stove. I am sure that a concrete base has to be poured first, but don't know how big to make it, and how deep. The chimney won't be over 25 ft tall. I have never seen the chimney materials, nor watched one being built!, however I am imagining rectangle concrete blocks, with a 8" hole in the center, that just stack up , with morter between. Is this accurate? Some one please enlighten me!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.