Posted by IH2444 on February 05, 2014 at 17:35:13 from (98.67.146.252):
In Reply to: Recycling parts posted by RCP on February 05, 2014 at 17:24:26:
RCP said: (quoted from post at 21:24:26 02/05/14) In theory this is true, if you rebuild a car or truck or replace the engine, you are supposed to bring it up to the current emissions levels. This also applies to heavy movers such as locomotives.
However, there is little to enforce this requirement, and it would be very difficult to get caught.
Regards
Rich
Yep. I thought this had always been this way since emission standards were set for vehicles.
the drive train components must meet emission standards per the chassis date of manufacture not the date of the replacement engine.
This post was edited by IH2444 at 17:36:20 02/05/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.