Posted by super99 on February 02, 2014 at 04:51:13 from (74.32.247.173):
The church I go to is on the south corner of my farm. My field has a large hill behind the church. A couple of weeks ago, one of the ladies my age said her Dad always said there needed to be a cross on top of that big hill overlooking the church. It's been bugging me every since. Looking thru my excess parts inventory for something to make it out of. I think the old 60' 8" dia auger is the best candidate. It needs to be big enough that it will stand out from a 1/4 mile away. The top of the hill is sandy and barely raises anything, so I'm not worried about loosing crop land, I'm thinking just plant it and farm around it. I'm trying to figure out how to use the auger for the cross. It's an old Koyker that is about 10' sections. I'm thinking 3 sections high with 2 section for the cross bar. Do you think I can just weld the cross bar to the upright and be good enough or will I have to reinforce and brace the weld joints? I thought about using the frame of the auger because it would be easier to work with, but I think it would be too small to be seen from a distance. The photos are of the church and the hill behind it to the left, next 2 are from my house looking at the hill, the old auger for a donor, and a better look from the church. OK, I'm cheap, looking to do this without spending very much cash, just use what's lying around. OR would I be better off to scrap the auger and buy a couple of poles and use them? It's plenty windy around here, so it needs to be strong enough to stand up to 40-50 mph winds once in a while. Any thoughts?? Chris
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
