having worked for a while with a hand start tractor that kicked back a lot - I can tell you that the open grip IS important, but the proper body positioning and partial crank angle is MUCH more important.
Don't EVER crank all the way around. Put it around 7:00 - 9:00 - lift up to 11:00 - ish.
Then PULL THE CRANK OUT - and put back to 7/9 for each additional crank until it starts.
(some people make the mistake of thinking that if they just turn it slow it won't fire!)
I believe the open-hand/thumb-off concept is to cover people who decide to crank all the way around.
Drives me crazy to see people doing full cranks.
If you're in the wrong position - over 12:00 and it decides to kick there - it's very likely going to break your arm. If your thumb is in the way - it's going to be folded right back out of the way by the crank.
When they bite back at you - you gain a whole new appreciation for how much power is in even a small 15 horse motor. I don't care how big you are, you aint stopping it.
It's so hard and fast that it rattles your teeth, and that's when doing it properly.
Time it properly - crank it properly, then you'll be fine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.