I've been "flashed" by having to work on the same table as another welder. The problem with getting flashed is you don't realize it till about 2 o'clock in the morning when it feels like someone is pouring sand in your eyes. A bad flash requires wearing an eye patch for a day or so and taking special eye drops. Luckily I've never had to do that. It's ALWAYS a good idea idea to have a Dr. check your eyes if you have the sand in the eyes feeling because you could have got something in your eye. If your eyes are sore and you start rubbing them and there's something in there, makes it even worse.
Like everyone has said, this shop needs to put up welding curtains between stations. You can get them all the way up to a shade 8 and they aren't too expensive either. No auto-dark helmet made is a clear state when not welding. Most are shade 3 that should prevent a minor flash. However, sometimes you have to lift the helmet up. Depending on what your son is welding, he may not be using a dark enough welding lens in his helmet and/or it might not be installed properly. There is supposed to be a gasket around the lens or in front of it to block any arc rays from going around it. Pulsed MIG may need a #11 or #12 lens depending on the individual welders eye sensitivity. The first thing your son should do is check that his helmet is a dark enough shade and it's working properly(auto-dark). Wearing safety glasses with tinted side shields is a very good idea to help prevent getting flashed. Your husband needs to be very careful around the sub-arc as well. Generally the arc is shielded by the flux pouring over it but if the flux runs out or is somehow interrupted, there is no worse flash than a sub-arc flash!!! Sub-Arc uses very high current and is an extremely intense arc without the flux.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
