Posted by John in La on January 11, 2014 at 09:44:52 from (96.33.136.54):
Moving forward with the planning of a new 750 sq ft dirt floor; metal siding and roof poleshed/garage/workshop.
Went to the parish office to find out about a building and electrical permit. The reason I enquired about the permit in the first place is because I want to put a separate meter pan and breaker box on shed. About 100 amps; to run my welder; some lights; ect. Was told that if I build what I call a carport (post and roof only) I do not need a permit for the building. No code to follow build it as good or poor as you want. If I put sides on the carport I need a permit; flood elevation; wet stamp plans; follow all 110 mph wind codes; ect.
So I have decided to build a carport only for now. hint hint.....
Now all I need is the electrical permit. Inspector was not in office for me to pick his brain so I figured I would get some "preliminary" advise here. I want to install a meter pan and breaker box; and maybe a plug for a welder and some over head lights. Nothing over board but just enough to justify installing a separate meter pan out there and get past this electrical inspection.
By code I understand I can put a meter pan and breaker box on the post of a carport; I just need to use a water proof outside breaker box. I understand that I can put a plug for my welder on a pole as long as I install a small waterproof box to put the plug in and run the wires in pvc (grey) pipe. I understand I will need to run the light wires in pvc and install a waterproof light switch.
What I am not sure of is what kind of light sockets he will be looking for since this will be under a roof but not in a closed in building.
What kind of electrical box is code for the light switch and light socket. Will metal boxes like the sell at hardware do?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
