OK, rotary switches are not spec'd the way most other switches are. You'll never see a "DPDT" rotary switch because there's no such animal. The are spec'd by the number of poles and positions. You then wire them up to get the particular behavior you need. To make a double-pole double-throw switch, you need a rotary switch with at least four poles and at least two positions. (A one-position switch would be quite odd, wouldn't it?)
I think your biggest challenge will be to find a rotary switch rated at 30 amps DC. You'll have an easier time finding a solution if you add a relay to the circuit. If you use a DPDT relay, then you can run the gauge through one pole and the valve through the other. Now all you need is a SPST switch. If you really must have a rotary switch, it will be cheaper and easier to find one rated at a few hundred milliamps than one rated at 30 amps DC. It will also be much smaller, so you stand a chance of fitting it into your dash.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.