Posted by Ultradog MN on January 06, 2014 at 16:32:54 from (174.20.229.160):
Jay in NY's post about the frozen squash reminded me of a night when I was living up in Anchorage in the mid 80s. I had an old cabover camper that I had parked on the back of an old truck and lived in that for 2 1/2 years in a trailer park there. It had a propane furnace and fridge which both worked very well. I kept it heated with a 100 lb propane tank and a 20 lb as a spare. To back that up I had an electric milkhouse heater which I never used but it was there if I ran out of propane in the middle of the night. So one night it was about 30° below. About 1:00 AM I woke up because it was getting cold in the camper. Furnace was out. So I dressed and went to change over to the 20 lb tank. Arrg, it was gone. So I went back in and went to turn on the electric heater. HUH? It was gone too! So I dressed up in my Carharts, crawled into a big sleeping bag and covered that up with blankets. Slept like a baby but boy was it tough to crawl out in the morning. Later that day I ran into my land lord and I asked him WTH happened to my tank and electric heater. He said, very casually, "Oh. I took them to try to thaw out the waterlines to one of the trailer houses." I told him how my furnace went out and the cold ordeal I went through. He said nothing. So I told him that everything in the camper had frozen solid and all may cabbage and potatos were ruined and I was pretty mad about it. He just kind of chuckled and said; "Well if you were a True Alaskan you would have known to bring your potatos and cabbage to bed with you and they wouldn't have frozen." And that was the end of it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
