Ok, I looked at my truck closely. Here's what happens:
A red power wire goes into the round flasher relay and a yellow comes out of it. That yellow runs up the column to the signal switch. A dark blue and a light blue leave that switch and go back down the column. There is a connector and then they run through the firewall using the same hole as the speedo cable. They are still dark and light blue. Right under the hole there is a large connector (probably 6 wires). They are still dark and light blue when they leave the connector but a dark and light blue branch off and go toward the rear of the truck. AT NO TIME IS THE BRAKE CIRCUIT ANY PART OF THE TURN SIGNAL CIRCUIT. The brake circuit is a simple power wire to the switch and then a wire to the light. It never enters the cab.
After this branch off at the connector the two blues run to the front radiator support where they tie into the signals. Dark blue is right side signals and light blue is left signals.
So, to answer your question, if you are tying the turn signal and brake lights into a common rear housing you are going to need to design a circuit yourself. They originally went to two separate light housings, thus the reason they can work independently.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
