Posted by Paul on December 22, 2013 at 12:38:06 from (66.60.223.232):
In Reply to: Pole Shed posted by john in la on December 22, 2013 at 11:23:54:
I live in a totally different world, its all about snow load here....
That said, for a smaller building 32 feet or less, stick built on 2 foot centers is typically cheaper. For buildings 48 foot or more then pole building is cheaper. Both use about the same amount of wood, just how it is spaced. The stick built is easier to put shelves, etc on.
For a roof no one uses tar any more, shingles of today are just such rotten quality, put tin on the roof and never have to worry about it again in your life. Around here, lot of tar roofs need replacing as soon as 9 years, even if its warren tied you have a lot of labor and fuss. No one wants tar any more.... They have thin sheets of fabric or bubble that insulates and sound proofs a tin roof quite a bit.
Up here, I would tin the whole building, and for that small a size I'd look to 2x 2 foot studs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.