Posted by Notjustair on December 14, 2013 at 17:45:25 from (174.250.160.15):
Many years ago this old house was heated by a Wonderwood circulator in the cellar that was ducted in. As upgrades came the stove was taken to the wood shop/garage and has provided heat there for about 15 years. The other day I put some hedge in it and I had to open the doors - the thermometer said 109.
Well, yesterday I discovered just how much terminal rust the old girl had. I installed a pot bellied stove in there today. It just isn't the same, but I was not going to spend $700 on a stove for the shop. I'm too stingy. I'll be comfortable but not in short sleeves.
Anyway, I am going to put in a wood burner back in the house to supplement the heat pump. There is no fireplace left and I really don't want to carry wood through the house to where the chimney is anyway. I am seriously considering an outdoor wood furnace that I can duct in. I run the HVAC fan year round so I could duct it in the trunk line and get good circulation.
Do any of you use such a setup? The neighbors had one growing up and loved it but theirs was not ducted in. The hot air entered through a large vent in the side of the family room. I don't think I want that look.
Oh, and I have to stay warm in the house so I can go out and chore every morning. On the tractors. See, it's related?!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.