I have a 33 loader system on my h. I have a 6 foot blade pinned to the front instead of the bucket. I have run the hydrolics from the pump to a splitter valve with the detent on the down pressure side then back to the resevoir. This allows down pressure so the blade wont float when its going through heavy snow. It holds the snow well but there are a couple quirts. You will need at least 2 weights on each side. I drive on flat ground and need that much. A set of chains wouldnt hurt and would be necessary if you are doing anything up or down hills. Or the rear will slide around and not push. Also make sure you keep the ground under the rear wheels as clean as possible or you will be stuck in 4 to 6 inches of snow. It just cant push if it cant get traction. Good luck. I love mine even though I dealt with all the above for the last 12 yrs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.