Posted by Rdandersom on December 08, 2013 at 14:18:36 from (204.237.47.120):
In Reply to: Powder Coating rims posted by Row Crop on December 08, 2013 at 04:22:26:
I was a leadhand for a powdercoater for a few years.We had contracts for new auto parts but occasionally we would sneak a piece or two on the line at night.Sandblasting is the way to go.We tried using the burnoff oven for paint removal but it never worked well.Once the rims are blasted clean make sure the coater uses a good zinc phosphate wash treatment.The zinc phosphate etching of the metal is basically your primer.Lastly with powdercoating less is ussually better.The powdercoating is a bit brittle after it has been baked and a thin layer flexes with the metal while a thick coat cracks and lets air and moisture in.Most people also don't relize that the curing process is not complete after the powder is baked on.A couple of days sitting on a pallet will toughen the coating and make it more scratch resistant.We did cure tests with acetone rubs on the line every hour and always got some colour tranfer even on cool parts.QA advised me to let iffy parts pass if we new the pieces would sit a few days in our warehouse as they would show no transfer after 2 days undisturbed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.