Posted by samn40 on December 08, 2013 at 08:53:56 from (81.129.32.232):
Some of you may remember some pics I posted a few weeks ago of the concrete floor we poured in my new shed
Well it is all set hard now and I found some time this week to make up a gable truss to suspend the lean-to roof without the need for posts. I spent a day laying it out and doing the cutting with a stihl 12" saw and got it all tacked together with my hobby welder. Then I used the Honda petrol welder to weld it up proper
I burnt a complete box(120) rods on this and £!5 of petrol!
I also took delivery of a truck load (600)of 18"x9"x6" concrete blocks for the walls. Now was a good time before the girders go up for the lean-to roof, as the block grab on the truck could set them where they are needed.
I used my old tractor and loader to lift and turn the truss for welding. This tractor can lift about 1200 kgs and it was near it's limit with this truss, guess the truss weighs a ton or so
I got a guy to help me for two days this week and we managed to frame the lean-to roof. The sheds are second-hand so I painted all the steel and creosoted the timber to make it like new!, At least if I have to put any new timber in the creosote will help everything to match....
I also opened a new entrance and fitted some gates, the small gate is for my daughter's pony....so she doesn't have to open up the whole entrance!
The new truss in place ready for phase two, (or the second shed!) The next shed will be 120x40, the lean-to is 78x25.Should hold/keep some machinery out of our damp climate!
Just though some of you might be interested in how we construct our sheds (barns!)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.