Posted by John in La on December 07, 2013 at 19:09:05 from (96.33.136.54):
Yes I need new rims but I am cheep and these tires still have a little life left in them. When the tires just have to be replaced I will buy mounted tires on new rims. This is how I made due till then............
Not real bad to start with
So I took the tire off the rim.
The more I tried to grind out or weld up the bad spot the worse it got. So I resorted to welding in a new piece of steel; forming it to the rim shape and grinding edges smooth.
Here is what it looked like from the outside.
Then I sanded; put some rust inhibitor on and primed the rim.
Then I cut up the old tube and stuck it to the rim with spray adhesive.
Went to a good spot in the rim and with enough heat was able to get a flat spot made for the valve stem.
Installed puncture retarder liner that goes between the tube and tire.
Mounted the tire and installer on tractor. On to next project getting steering box repaired.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.