I agree with your shop, use loctite. I have two New Hollands where I've loctited axles bearings and they are still nice and tight. Clean both the shaft and the bearing ID with break cleaner and apply Loctite 7471 primer for a good cure. The retaining compound to use is loctite 680 and can be ordered from McMaster.
I would be very hesitant to touch that shaft with a stick welder as all you would do is add stress concentrations which weaken it. Spray weld or brazing is the only way I would build it up. Those axles just work way too hard and all that will eventually happen is you'll induce a fatigue crack if you stick weld on it.
The key with New Holland axles is make certain you get the preload right. And with the outboard bearing, if it's spun, make sure the shoulder the bearing presses against is smooth and doesn't have ridges. If it's not, you'll end up back at the same spot.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
