Yup , center bearing. IH tractors use very similar starter,(along with a lot of other machines) and some have center bearings and some don't. The smaller tractors like a Farmall C did not use one and I have seen starters on H Farmalls that did not. Some times the drive end housing is machined and holes with tapped threads for the bearing, and some are not. I installed a lot of them over the years and it really helps those 6 volt grunting starters. When you throw the juice to that starter the magnetic fields push and pull that armature toward the pole shoes. If the armature touch's or even gets closer it affects the torque delivered by starter. I have been around a few WC's and know they never had an extra lively starter either so I think a center bearing would be good for that starter. Also, a lot of the commentator end frames do not have replaceable bushings in them and a center bearing will support that armature much better even if that end is worn. Those end frames are expensive to replace if worn and no bushings in them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.