Posted by Bret4207 on November 19, 2013 at 04:00:21 from (64.19.90.196):
In Reply to: 2N vs Back Blade posted by Samuels68 on November 18, 2013 at 20:27:39:
I have a 7 footer and an 800 with loaded rears and double ring chains. In significant snow it will just barely handle it. A 2n is going to be doing good with a 6 footer- maybe. The problem with a back blade is that tractor can't really push well going backwards and you can't pull more than a blade full and then you have to have someplace fresh to dump it each pass or every other pass at best. A back blade is okay for 4-6" but it's torture for much more. A front mount is worlds and worlds better, but you can buy a beat up plow truck for what that would cost you. Of course, you can often buy a beat up plow truck for what a new back blade costs too!
We measure our snow in feet here.
This post was edited by Bret4207 at 04:01:14 11/19/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.