I have re-soldered leaking floats but never have reshaped one.
Full of liquid? It looks like a dot of solder(in the photo)is closing the pressure equilibrium hole. This hole is open during the manufacturing process to allow the expanded air to escape while the float seams are soldered.
You may get lucky and if you heat the float, it may expand the liquid/vapor and pop your indentation back out. You may have to restrain the other sides so they don't become bulged from the pressure.
On my 560 Farmall, I had gasoline in my float and used an electric heat gun to heat just enough to create sufficient vapor pressure to force the gas out of the crack. (don't get too close as the heating coils are hot)I then opened the "dot" to allow pressures to equalize while soldering. Since my crack was close to the attaching bracket, it acted like a bit of a heat sink. I used the heat gun to give it a bit of preheat (just like welding) and then soldered the crack shut. I then let it cool somewhat and then soldered the "dot" closed.
I don't know, would plaster of paris restrain the other sides of the float enough and then apply heat to pop the dent back out? May want to tape off some of the bracket as chipping out plaster of paris from the convolutions may be a bit tedious.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.