Posted by showcrop on October 27, 2013 at 19:27:40 from (75.67.231.80):
I built a track plane for grooming the pulling track at some pulls in the local area where we use our local sled instead of one of the more established sleds. We had a pull Saturday and the host farm owner borrowed a compact JD from a neighboring business to pull the drag because his small tractor was out for repair. Being the builder of the plane I have unwittingly become the one to have to keep somebody on it. I wanted to get it properly adjusted anyway, so I got into the cab and started dragging. After a couple of passes I pulled down off the track and turned to come around, and the tractor came up on two wheels!!! I straightened the wheel quickly and it came right back down but this was a shock!!! I would never have entertained the least concern of instability on any other tractor that I have ever been on in this situation. The incline was nowhere near steep. I stopped to check things out. The drag was well below the center of gravity so it was adding to stability. The cab on this little tractor adds a considerable amount of weight well above the CG. The loader frame with no bucket even though down, perhaps does not help. The biggest thing appeared to be that the rear tires were set in as close as they could possibly be. I take responsibility for not having walked around it before starting to work it, but it appears that the dealer set up was far from correct for this little tractor, making it necessary to operate it with much more than normal caution. You can never fully depend on those before you doing things exactly right.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
