Posted by Billy NY on October 18, 2013 at 06:16:13 from (72.226.79.200):
In Reply to: Grain slab size posted by JEH on October 18, 2013 at 05:28:39:
You could see if the manufacturer has details on installation, ie; slab connection, for dimensions, size etc. steel plate, anchor size and concrete details, thickness, reinforcing etc.
If not, size the steel plate, weld, steel should be protected, meaning rust and mill scale removed, hard to field galvanize, maybe something durable like ship paint or something substantial to stop rust. It may possible you could have legs added to the steel plate, holes drilled in both the plate and legs, as well as the legs to the grain bin to match, most steel or welding shops should be able to send out those pieces for galvanizing, connect the 2 in the field already finished, place on your slab, be prepared to shim, I suppose you could use slots for adjustment, but shims would be better, like setting steel column base plate onto a column footing.
Once you place the bin on the slab, that has been poured in advance, say 28 days before, you can easily drill into the slab and use epoxy or mechanical fasteners such as Hilti sleeve anchors, expansion bolts or another manufacturer of same. I'm sure you could template the connections, and set into the concrete, but its just as easy to drill and install later. When placing reinforcing in the slab, make sure to keep it clear of where the fasteners will go, and when sizing the slab, make sure the fasteners have enough distance from the edge of slab, as well as your base plate detail maintaining enough edge distance of the fasteners to each one. You don't want mechanical fasteners to close to each other, epoxy may not matter so much, but an expansion bolt to close to another could fracture the slab when you tighten it down. Should be a relatively easy install, just some tips to help !
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
