Posted by Indiana Ken on October 10, 2013 at 17:17:57 from (66.249.233.14):
In Reply to: New Gasoline posted by David G on October 10, 2013 at 15:42:36:
Quoting Removed, click Modern View to see
It was my understanding that "most" gasoline was being refined to 84 and 91 octane levels. The big deal with the lower octane (84) is that it is cheaper to produce, as another poster noted. Also, ethanol is cheaper than gasoline on the commodities market so adding ethanol gets you 87 octane - very cost effective. IMHO, this is the best kept secret in the oil business.
84 + 10% ethanol = 87 octane.
84 + a splash of 91 + 10% ethanol = 89 octane.
91 + 10% ethanol = 93 octane.
For ethanol free gasoline:
84 + a splash of 91 = 87 octane
84 + 91 = 89 octane.
91 = 91 octane.
I have seen 93 octane ethanol free gasoline and have always been puzzled if that is a special run truck load or what...? The Renewable Fuel Act passed back in 2007 required a minimum number of gallons ethanol shall be blended per year. The number increased over the years however the petroleum industry has blended far in excess of the minimum requirements. If they have met the minimum they do not have to blend additional ethanol. OR - perhaps they feel there is a market for non-ethanol gasoline and have decided to simply pay the fines.
Perhaps someone else closer to the industry can comment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
