Old you can make a cider press real easy. Just take a five gallon bucket drill a row of holes around the base. I used a 3/8 drill bit.
I then made a frame out of 2x4s and 2x6s bolted together. Then for the press part I used an old car jack. You know the old bumper type.
I made the frame with two 2x6 across the bottom. I spaced them about 6-8 inches apart. I nailed a 3/4 piece of plywood to the top. This held them a part and made a place for the five gallon bucket to set. Then on each end I used two good oak 2x4s as uprights. I bolted a single oak 2x6 across the top. I put a short piece of angle iron in the middle for the jack to catch on. For the push board I just screwed two round pieces of the 3/4 plywood together.( used the bottom of the bucket as a pattern) I just set the jack on the plywood and under the cross board. Jack it up tight and leave it for just a while. Come back and you will get a few more clicks.
Almost forgot. I took a large flat pizza pan to set under the five gallon bucket. I just bent the lip on one side so the apple juice could run off that side. I just put a short one gallon pitcher under that to catch the juice.
Just think about how a hydraulic press is framed. So just make one out of wood and then use the bumper jack for the force part.
I built it all out of things I had laying around. We made cider every year until the last one my first wife was alive. My oldest son still uses the old press to make some each fall.
I always cut the apples into quarters an then pressed them. It seemed to work better.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
