Posted by Goose on August 31, 2013 at 06:19:02 from (70.198.7.218):
Over the years, I've seen and heard all of the warnings about taking precautions against being injected by a power washer. Yesterday, I managed to do it.
I was cleaning off the north side of our garage with my gas powered, 2300 psi unit. Some water must have hit the ignition, 'cause the engine stopped. Checked the gas, had plenty of gas. As ya'll probably know, they start easier with the trigger pulled on the wand so you're not pulling against the pump.
I held the wand in my left hand and pulled the starter cord with my right. The engine fired right up, and somehow the wand got away from me and hit the palm of my right hand at the base of the thumb. My hand was only about 6" from the end of the wand when I got hit. Dang, that hurt!
Tore up my hand some, but not too bad. My wife was there, and I managed to shut off the engine. I assumed any water that had been injected into the hand would drain back out through the wound, and apparently it began doing so.
I've had wounds worse than that, and patched them up and went on working, but since this was new to me, we decided to go the the ER at our local hospital to be on the safe side. At the ER, they were more concerned about infection and when was my last tetanus shot than anything else. Anyway, they gave me a tetanus shot, patched up my hand with anti-biotic ointment, and sent me on my way.
From comments the nurses in the ER made, apparently this isn't an uncommon occurance. They'd all seen it before. But, like any accident, all it takes is one wrong move or one unguarded moment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.