Engine Boiler pressure for a Railroad Steam engine rose as horse power increases increased and engines were refined.. The use of Super-Heated Steam revolutionized the steam engine and brought in the age of "Super Power" or steam engines. 1890's era steam engines were operated at around 125 PSI. C&O eventually increased that to 250-265#. Penn used 300# in their most modern steam engines. There were some experimental steam engines that used 450# (or more), using the steam twice (Compound). Steam Farm tractors (as far as I have ever heard) used AROUND 125# and few (if any) ever had super-heaters. Where steam Farm tractors may have approached 100 Horse Power ( Boiler HP), Railroad Steam Locomotives were built to produce as much as 7,000 Boiler HP and 6,000+ Cylinder (Drawbar-Horsepower). The two are as far from "Apples and Oranges" as you can get.. A Large, Modern Steam Locomotive would have up to 125 SQ FT of Grate area and under Full Power, require 100 lbs (coal) per Sq Ft an hour.. Or 12,500 lbs of Fuel/Hour..and if it needed MORE power, it could be "Over-Fired", causing a lot of smoke, but boiling even more water to make MORE steam.. A pound of coal would bring approx. 7# of water to 300 PSI so, the above steam engine would use 87,500 # of Water/Hour.. Not quite like a Steam tractor's appetite.. The NYC Niagara's boiler was made with 4" Flues, to allow it to be "Over-Fired" (if need be), drawing the fire right into the Flues.!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
