Posted by Eric Rylander on August 19, 2013 at 19:52:43 from (69.136.36.18):
Me and the mother in law's old man had this road trip planned, I drive to VA from GA Wednesday night with a trailer, we leave their place Thursday AM and drive to MN, planned to stop and catch a few hours sleep in the truck and make ti to MN Friday mid day.
Have a wheel seal on an 8N Ford to do, find out why the IH B414 diesel of dad's looses prime, patch a shed roof, and do some fishin, then load up an old wagon running gear to take back to VA, leaving early Monday AM. I have to be at work Wed AM in GA.
Seems Chris was in an ATV mishap and dislocated his shoulder and had to have his ear sewed back together. He's in a bit of pain but is home now, and is still planning to go. What a man!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.