Posted by Chip812 on August 09, 2013 at 11:31:52 from (216.226.180.3):
In Reply to: To cut the hay or not? posted by picassomcp on August 09, 2013 at 11:15:51:
You, with your 3 years of experience, have vastly more experience than I do... However, I'm going to post a comment. Not because I have any particular knowledge, but to maybe spark a continued dialogue that may prove educational. Here goes:
It would seem to me that the inputs into the hay would need to be considered as well as the timing. Your time, wear/tear on equipment, and fuel costs are 'fixed'; i.e. the same every time you cut. Seems to me that you should wait and only do one more harvest to maximize your profits.
There, I said it. Now to see if there is agreement or disagreement.
Edit: I can already tell it is way more complicated than I had anticipated.
This post was edited by Chip812 at 11:33:50 08/09/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.