Posted by ericlb on August 04, 2013 at 06:30:54 from (70.41.154.247):
In Reply to: A non-rattle rain cap posted by 2510Paul on August 03, 2013 at 16:53:58:
never heard one that didnt clang, but that being said you can experiment a little, i shaved a little off the cap on my little cub, so the counter weight is more effective,[ i guess welding a washer or nut on the counterweight would do the same thing,but its a very sensitive thing it takes very little weight to be too much then it wont close, now it stays open steady even at idle and on a cub thats not much air going up the stack at idle, it still fully seats when the engine is shut off, the other thing you can do is look at exhaust tips at a good auto parts store, what you want is a mini version of a truck stack tip not just a miter cut, but one with a slight turnout at the top before the miter cut, rain wont go in there unless the wind is blowing that direction, and you can always turn the tractor if it does
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.