Posted by Mike in Mn. on July 31, 2013 at 08:43:49 from (74.37.55.114):
In Reply to: sand blaster posted by basil greenleaf on July 31, 2013 at 05:50:37:
I have a pressure pot blaster that holds 90lbs of sand, bought it from Northern tool years ago and a NAPA commercial compressor, 5hp, 80 gallon tank. I have a sharp filter/regulator mounted right on the blaster plus all the filters and lines in the shop, never have a problem with moisture. The amount of air needed depends on the size of the nozzle used. I run 80 psi and a 1/8 inch nozzle, never run out of air and that set up is suppose to do about a square ft. of area per minute, which is about right. I use fine white silica, it costs about 11 bucks for 100 lbs at the local hdw. store. The nozzle will last for about a ton of sand. I have used this set up for more than 20 years and am more than happy with it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.