I've been having more trouble with mine the past few years with some of the newer twines. Make sure the twine tension slides in the twine box aren't too tight, and after the needles trip into the chamber, make sure some hay is still flowing. I have a tendency to hit the brakes as soon as the signal goes off, and the needles haven't gone into the chamber yet. So, there's no hay moving underneath the needles and the twine just hangs there. Another thing I have done with mine that seems to help, is to take some strips of 3M deck tred and stick them on the lower roller. It's really shined up and slippery. I wiped it off good with alcohol swabs and put a 12" strip between each of the friction bars. It's rough like sandpaper, and seems to provide some extra grip on the twine. Nothing has been foolproof, but it's helped. I have also noticed that a heavier windrow starts better than light material- keep the head loaded. Another trick I have done on my machine is to put two pulleys on the front left side and looped the twine over them- one pulley for each side, and painted a cross on them. It makes it really easy to see the twine moving or if one side didn't start for some reason. These are just small idler pulleys on a bearing- the twine does one loop over them on the way across the front to the glass feed tube going to the needles. They start to spin as soon as the twine starts to feed. Very easy to see..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
