Posted by fixerupper on July 16, 2013 at 11:07:29 from (100.42.82.30):
I live right on the banks of a drainage ditch with a bridge right south of our lane. The bridge is about 300 feet from our house. The ditch was dug sometime in the teens so I assume the bridge was built about in that time frame. Tomorrow the machinery comes to remove and replace it with two tubes. The engineer said it'd take about two weeks. This bridge is between our two farm building sites, with my son's house and the machine shed to the south and our house and the shops to the north so for a couple of weeks we'll have to make do. I'm thinking of throwing a plank across the stream so our grandkids can get across to grandma's house and the chickens and garden. Hmmm, maybe I can talk them into making me a golf cart crossing too. (wink)
I grew up playing under this bridge so there's a lot of good memories of just sitting there in the shade pulling the leeches off my feet and ankles and watching the water go by on a hot summer afternoon. My son did the same thing and this spring the granddaughters were down there catching frogs. Anyway by tomorrow night it might be just a memory. The good part about it is when they are done there will be no narrow bridge to bother anyone's machinery and it will look a lot nicer too. I'll try to post a pic of the bridge as it looks now if I can. The other night I couldn't post a pic to save my life so it might not happen this time. Here goes---
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.