Had mine out Laproscopically in Feb 1996. Doc said be at the hosp. 6:00 AM and I was, no Doc, had a blizzard the night before, He showed up at 9AM started right in and got the job done. If he had been on time I would have been home by 4pm but made it by 6. The next day I felt like he had left a knife in me, but the following day I felt pretty good. At the checkup he asked me if I had worked with chemicals, yes, 5 yrs as Commercial Applicator. Prowl is the only one that bothered me when I had to use it. One day after spraying a lot of it I told the boss that was my last Prowl job. Doctor took pictures while he was in there and gave me copies. Said my liver had a little damage, but it's never bothered me and they still check my liver function every 6 months. Don't worry about it, it's just a routine operation these days
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
