Forgot a couple of things. On corners in black dirt it's hard to keep them in place but I use double bracing on 10' centers.
Double bracing is two brace posts in each direction in addition to the corner post. Using steel the span from the corner to the mid post is horizontal, but the span from the mid post to the end is at about a 30 degree angle (diagonal bracing to keep posts straight with wire strain on them) and that second post really only needs to be a stub (to weld to) with all posts set in concrete.
What this does is the mid post takes the load of the fence but rather than trying to pull the corner post up, as is the post going 90 degrees away also trying to do, it is resisted by the stub post and the angled brace to it. I guarantee you this little bit of extra effort makes a whopping big difference in keeping the corner in the ground.
I use 8' posts and usually leave about 10" above the top rail. The rest I push in the ground with my FEL. The horiz brace pipe is slightly below the top rail.
The 10' spacing is this. The longer the span on the bracing, the more effective it is in resisting pulling out. Holes are: I use a 12" auger and run it all the way down (2 1/2' or so) and fill with Sacrete, usually dry as after a couple of rains it sets up. I have pulled up posts secured this way and I guarantee you the crete WILL set up like this.
On runs, I usually work 300' at a time which means that every 300' is a pair of posts, 8' on centers, cross braced which gives you a tie off point for the next 300' and helps to keep the fence tight.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.