Posted by jfred on July 06, 2013 at 17:47:00 from (74.118.114.198):
I am working on a Continental F162 engine that someone had been into prior to me getting it. I have decided to go through it myself after having found some questionable work having been done. Anyhow my question is....how are the timing gears oiled on this engine? As you can see in the attached picture, there is a hex socket pipe plug threaded into the front oil galley port. Is this suppose to be this way?? or should it have a fitting like the one I have held in my hand?? The part in my hand is a fitting that goes on the F600 series Continental engine blocks. Once oil pressure builds in the galley, oil is forced out the tiny hole drilled fitting that shoots a stream of oil onto the camshaft gear. Can anyone who has worked on a Continental F162 tell me for sure what this engine should have? Thanks in Advance!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.