Posted by John in La on June 25, 2013 at 07:40:44 from (184.38.182.247):
I enlarged the kids bath room and moved my washer and dryer in the room. Problem is they are on a interior wall now. So I cut a hole in the floor and routed the dryer vent out this hole. This is right next to where I use to have a gas central heat/ac unit. Since I switched over to a heat pump the old exhaust stack for the gas unit is no longer used.
Jump to today....... I was going to remove the old heater vent and repair the roof but got to thinking...... Could I....Should I.... have used this old vent through the roof for my dryer.
Pros... It would cut my dryer vent tube length in more than half. It would get my vent tube from under house where it is always damp; never wet but damp/humid because the sun never hits this area. Remember we get over 60 inches of rain a year every year.
Cons... The tube would now run straight UP for several feet. This is a stacked unit and the dryer is on top so it may be 5 or 6 ft from the dryer to the roof line. The dryer would vent on my shingle roof maybe causing lint to dirty the shingles.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.