Posted by willie in mn on June 24, 2013 at 17:36:13 from (205.188.116.10):
In Reply to: Hoe Design posted by fergienewbee on June 24, 2013 at 13:21:55:
My Dad had one way back in the 50's. Diamond shape, laid flat, with the long axis cross wise. Cut on pull or push, slid just below the surface. Couldn't find one like it, so made one a couple years ago, spent less than 5 bucks. Took 2 sickle sections & welded into a diamond shape. Then welded on a piece of 1/8 x 1 in strap iron covering the first weld & bent the end 6 in or so up at about 45° angle, enough to bolt on a handle. Took about 1/2 hour to make it, with time out for a cold drink. With the points the wide way, it lays flat, slides just below the surface, clips the weeds off without having to move a lot of dirt. One of these days I'll figure out how to post a pic. Willie
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.