Let's try this again!!! If the tractor the JD 260 came off of is a JD row crop tractor under 150 hp then it will bolt right on. They all have 19 1/2 inch wide frame rails. I am not going to list the 30-40 models that would work. Example: JD 4440, bolt right on. JD 4640 would not work, the frame rails are wider on the 4640. Note the JD 4640 is over 150 HP.
Also the larger utility tractors ( JD 2840,JD 2940, JD 2959,JD 2955, JD 3055, JD 3155, etc) had side frames and the same width frame as the row crop tractor. The utility tractor just needed an axle support that went under the back axle. That support will work on the JD 4010 but it will be about 1 inch too low back at the axle. All you need is a piece of flat stock an inch thick with two holes drilled in it. Then just use longer axle clamp bolts.
So We really need to know WHAT THE LOADER IS ON NOW!!! John Deere made brackets to put a JD 260 loader on more then 50-60 models of tractors. Some will work and some will not.
I am not trying to be a smart butt here but I can tell you in under a minute talking if the loader will work. Posting I am guessing what the HECK the loader is on now. So I have ZERO IDEA if it will fit. NOT ENOUGH information. So post what the loader is currently on or what it came off of. Even better email me. I will send you my phone number. We can talk it out in just seconds on the phone. I am already tired of typing about it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.