The auger is held on by it's drive pulley. It sounds like the pin that holds it in place is not doing it's job. Fairly easy fix. Just take the shield off of the belt drive & look for the pin, or lack there of, behind the pulley on the auger. Replace if necessary. Don't take the two pulley sheaves apart, unless you like chasing washers around or need to change the speed. The pulley was designed to slide off of the shaft, complete. If you need to pull the auger, you'll also have to knock the pin out of the drive pinion at the end of the shaft located by the knotter. The whole tubular arm pulls right out the side. Take the wind guard off of the pickup & roll or lift the auger out. It's been a while since I had to do it, but I'm pretty sure that's how it goes. I don't know if they have a reprint the service manual on the site, here or not. If not, CaseIH has a downloadable version on their site. Look for GSS-1348.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.