EXCELLENT QUESTION, Im no metallurgist or chemist but here are my thoughts:
Does the "green powder oxidization" inside a bat cable casing have any affect on the current carrying function of the cable. That whats called "patina" spelling????????? Green copper oxide???
Looks to me like the chemical process of oxidation causes the breakdown of some of the copper (you now have less wire circular mils) and converts it to some extent to a conductor (copper oxide) thats likely higher resistance then the pure copper it was before, SO MY BEST GUESS IS THE NET RESULT IS SLIGHTLY MORE RESISTANCE (now less copper in paralell with higher resistance copper oxide) THEN IF IT WAS STILL PURE COPPER
I guess I'm asking whether current travels in the individual wires or does it travel over the surface and what role does the powder play if any?
Sure current travels in the wires and at that low DC frequency "skin effect" is negligible but again it looks like you now have less pure copper as part of it got converted to copper oxide so you have copper in paralell with higher resistance copper oxide SO ID GUESS WIRE THATS PART OXIDIZED has to be more resistive then if it were still pure copper
Hey, this is as much a chemistry and metallurgy question then electrical engineering and IM NOT knowledgeable on EITHER so no warranty but still the above makes sense to me. Less copper and instead some of it now copper oxide just has to be a worse conductor then if all still in the pure copper state??????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
