It's been many years since I fooled with a mechanical VR. But one thing is for sure. Current into your battery from the regulator only goes one way....into it normally.
Starting with the + battery terminal, following the wiring. First is the large wire that goes to the starting solenoid. That is your high current wire and you don't want to mess with that.
What you are looking for is the smaller wire (12 AWG) from the VR that connects to either the battery + or to the input terminal on the solenoid.....solenoid terminal used as a junction post .
I don't know how much charging current a mower generates, but it's not much as the battery isn't all that big nor is the load.
For an outside number say 10 amps. Probably more like 5 but use 10. Go to Radio Shack and buy a stud diode rectifier of 15-20 amperes. Tell the salesperson how you want to install it and get some adapter terminals. If you want to just cut the wire and insert it, tell him. If the VR wire goes to the solenoid tell him that one end of the diode will be attached to a (3/8" I think is the dia) stud and the other will be to a bare wire, or the terminal you took off the solenoid.
Position the diode so that it does not touch anything metal. If attached to the solenoid that will take care of that.
The diode has a symbol on it consisting of an arrow attached to a horizontal line. This shows which way you turn it to hook it up. Install it so that the arrow is pointing towards the battery.
That will drop your charging voltage to the battery a little but it won't be all that much and you probably will never know it.
Then whatever your charging circuit decides to do in the off period won't matter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
