Posted by tomtirediron on June 02, 2013 at 07:25:31 from (208.123.10.195):
In Reply to: OT Only in Illinois posted by super99 on June 02, 2013 at 05:38:07:
LOL, just came back 10 mins. ago from a 35 mile roadabout the police on the gravel roads with a trailer I can't muster up enough patience to attempt to license. It's a home made tandom dump trailer. Minnesota and Ill. form must be similar as they want a full accounting of all the materials used ect. Built it close to 20 years ago from a lengthened 63 Chevrolet truck box, the running gear out from under a large portable welder- air compressor combo and sheet steel I cut out of 2 old fireplace inserts and they think there going to see recepts? Yup, mighty important to make it as darned difficult and expensive as can be.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.