Posted by Crazy Horse on May 26, 2013 at 10:06:30 from (75.158.38.154):
I have a Massey Harris 101 Junior with an Autolite 6 V 3rd brush generator. Just lately, it seems to be charging at a much higher amperage rate than before. With the 3 position light switch in position #1 (low charge), the charge rate approaches 20 amps when in operating RPM range. It drops off to about 3-4 amps at slow idle in this #1 position. When in the #2 (high charge) position, it pins the needle past the top 20-amp mark on the ammeter. When in #3 (high charge with the lights on)it drops back down a bit but still approaches 20 amps of charge. Seems to me this is a bit high. The 3rd brush is adjusted into the lowest amperage output position in its rotation.
Here is my question ..... does this seem to be somewhat high for amp output? And can my battery be damaged by this rate of charge?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.