Insulating the roof will stop the sweating. The stuff in my building comes in a roll about 3' wide and contains a white outer layer, 2 layers of alum foil each side of center, and a bubble wrap core. Guarantee you it doesn't drip. Course part if that is to install roof vents to let the building breathe and allow the trapped moisture to exit. No vents, expect moisture problems in the colder/ seasonal changing conditions. I have 2 10' roof ridge vents on a 50' building. I have never had rain blow in using the ridge vent type of vent.....cupolas yes on other buildings. That's why I went with the ridge on this building.
I chose a wood pole barn frame over steel because I liked the wood strips every 2.5 ft allows for 29 ga. steel which is plenty for sides and roof. I like a pole barn because it is IN the ground. Mine is 90 mph wind resistant, guaranteed.
On the pole barn you can concrete after building, using the building forms for your floor as they are, or no concrete. Still have a tough building.
The steel sheets can be cut to order for quick assy and over the years I have found that the metal to wood screws, that the steel supplier usually carries are perfect. No nails backing out over the years. My barn is 30x50 with 12' sides and the roof and sides are made up of one sheet of steel. Goes up really easy and fast.
A 3/12 pitch works out great and allows for a shed on the side with adequate head room. I added a shed (roof) running the full 50' length x 15' wide. 15' seemed to be too much initially, but it is what you want. Room for your tractor or whatever and room to get around or by it to do other things.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
