The little time it takes to remove the grill and radiator support will pay big dividends. I would replace all the freeze plugs those are know to leak and a bear to replace when the engine is in the frame. I also would replace the crank sensor with a OEM while their, the valve cover gasket and the o-rings that may be at the oil filter adapter. Engine mounts also settle over time so new mounts would be considered.
Those start head bolts are not that bad to get at you may have to lower the rear of the trans to access them. You can use a regular hex head bolt when you go back.
With the grill and radiator out they slip right in :wink: Chrysler has a paper tab that fits over the crank sensor so as not to damage it wile installing it you may look into that though not necessary its just a precaution.
One more thing I do on most all of them is cut the frame to access the drain on the AC evaporator then add a hose so the condensed water runs out on the ground instead of down the frame Chanel. It ends the dreaded wet floors on the passages side. (if you have that issue if you keep it long enoufh you will) I know this applies to the 90's models not sure about a 01.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.