Posted by Ralphwd45 on April 23, 2013 at 20:57:51 from (216.227.112.136):
Went fishing, locked the old 75 dodge up at the landing, with the keys inside. I went to load the boat back up, and found my boo boo.I needed a tool, to raise the vent window lever, so I could reach thru the vent, and open the door. Could find nothing to use in the boat, or truck bed, so I took mt schrade oldtimer, out of my pocket, and slipped the longest blade, thru the rubber vent gasket, and under the wing window latch handle, and started lifting-prying upwards, untill the big blade sheared the piviot pin in the handle.Thankfully, the latch was moved enough, when it broke, that I could get the window open and open the door. I went to our local Ace Hardware store, and they had quit handling pocket knives. Now I don't want just any old pocket knife, I want a schrade 3 bladed uncle henry, or oldtimer in the 3 1/4 " length.It fits in my pocket well, is always available, and I use the electrician blade, for a lot of things besides stripping wire, the shortest blade ( if kept sharp), is my casterating blade, and then the longest blade does's every thing else, from peeling apples,cleaning fingernails, scrapping gasket material, cutting hoses, cutting rope ECT. OH by the way! Did you folks know that cleaning your fingernails in public, is very crude! SWMBO thinks I should go hide and do it! Kinda like going to the potty! She also doesn't like me to whip out my oldtimer, at the resturant, and pick out the crab meat from the leggs! Just doesn;t appreciate a useful tool! Well I feel hand cuffed without my pocket knife, and am ordering one from Schrade, online.I just wondered if any one else depended on their knives like me?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
