Heres how to wire it, same info I already posted below but you asked again and Im here to help best I can:
BAT on VR to Load (NOT battery/starter) side of ammeter
FLD on VR to gennys FLD Post
ARM/GEN on VR to gennys ARM post
LOAD on VR wires up to BAT INPUT terminal on lights or ignition switch, it furnishes hot battery voltage for loads.
Often on those 4 terminal VR"s GEN/ARM is off on one side or underneath all alone
If the VR isnt marked, one thats open circuit to case frame is BAT,,,,,One with very low ohms to case frame is FLD,,,,,,,One with maybe 20 to 50 ohms to case is GEN/ARM,,,,,,,,LOAD terminal has low resistance over to BAT terminal
The VR DOES NOT GET POLARIZED, ONLY the Genny, so if its polarized youre good to go.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.