I remove the old grease fittings an take parts/brake cleaner and clean what old grease out I can. I then install new fittings. I usually put a round bale on the running gear front end. They will usually set on just the coupling pole and the front bolster well enough to act as a weight. I then take a tractor at a 90 degree angle to the wagon and hook it to the hitch. Then just wiggle back and forth real easy. They usually will wiggle just a little bit and pretty soon you can get them to take some grease. The round bale is heavy enough to put some force on the spindles but light enough that if they are stuck too tight the wagon can skid and not break anything.
If this does not work than I take a Rose bud heating tip and heat the heck out of the outside tube. This will usually get the most stubborn ones to move.
I did have one that would not even move when I did that to it. I ended up taking a cutting wheel and splitting the pipe top to bottom. I then was able to get it apart with heat. I then just welded the slot back shut. I did have to ream the bushings out as when the weld cooled it shrank the pipe some. But I did get it to move.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.