Posted by Tony in Mass. on March 25, 2013 at 21:00:00 from (76.127.225.182):
In Reply to: Reloading safety.Pics posted by LOU from Wi. on March 25, 2013 at 19:24:55:
Is this soft lead or FMJ? Lead won't usually bulge the brass, but hardball will, so will the expanding die not adjusted right. Study the brass closely before and after the resizing die, and study again after you seat the bullet. Atleast you will know which process is deforming them. A hot load will distort the casing too, and just keep checking every shell at evey stage with the dial caliper. Now remember, never force a round into a chamber, if it don't go, it's a no go, stop. Some barrels have no 'leed in' so bullet head can dig into rifling, but action should close normally. These aren't unsually heavy bullets are they? And.... that new win brass might just be too thin... mike the thickness of that too....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.