I thought they do a bit better than 12 gpm but I may have a bit larger engine pump on mine... What I'd suggest is that you turn the detent screw on the remote valve in a turn or so... just enough to prevent the loader supply spool from kicking out on it's own... then you don't need to tie it off. All I've ever done is give the valve handle a whack down when I need to use something else, then haul it back up when I need the loader again.
Also... mabey I should have reread your original post... but are you trying to hook a third function on the loader arms? You should look at your present loader valve and see if it's got a plug on the side directly above the return port... if it does, it's likely a power beyond type of valve. IN that case you can simply buy a single spool Gresen tandem center valve and plumb it to the PB port... and then tee the returns together from the two valves. That's how ours has been setup for 20 years. On the other hand... I'd much rather have a 3-4 spool stack of CCLS valves on the loader frame and eliminate all of the OC valves...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.