Texans were becoming increasingly disillusioned with the Mexican government. Many of the Mexican soldiers garrisoned in Texas were convicted criminals who were given the choice of prison or serving in the army in Texas. Many Texans were also unhappy with the location of their state capital, which moved periodically between Saltillo and Monclova, both of which were in southern Coahuila, some 500 miles (800 km) away; they wanted Texas to be a separate state from Coahuila (but not independent from Mexico) and to have its own capital.[10] The other interest of the Texans was representation of their interests in the government. They believed a closer location for the capital would help to stem corruption and facilitate other matters of government.[citation needed] Texans continued to lobby to overturn the laws of 1830. In April 1833, settlers called a convention to discuss proposed changes in immigration, judicial, and other political policies. The delegates also advocated separate statehood for Texas and elected Austin to carry a proposed state constitution to Mexico City. The new Mexican President, Antonio Lopez de Santa Anna, approved many of the proposals, but refused to agree to separate statehood; Austin was jailed when he wrote a letter advocating that Texans act unilaterally on statehood.[11] In 1834, because of perceived troubles within the Mexican government, Santa Anna went through a process of dissolving state legislatures, disarming state militias, and abolishing the Constitution of 1824. He also imprisoned some cotton plantation owners who refused to raise their assigned crops, which were intended to be redistributed within Mexico instead of being exported.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
